Initial Use; Beurer Lightup" App Features; Moodlight - Beurer TL 100 Mode D'emploi

System requirements:
TM
– iOS ≥ 12.0, Android
– Bluetooth ® ≥ 4.0

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 10 cm and
40 cm between the user and the device. The lamp is most effective at this distance. Ensure that there is a mains
socket close to the set-up area. Arrange the mains cable so that no-one will trip over it.
Power supply
Important
To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains part
described here.
1. Insert the mains part into the connection provided for this purpose on the rear of the daylight therapy lamp. The
mains part must only be connected to the mains voltage that is specified on the type plate.
2. After using the daylight therapy lamp, unplug the mains part from the mains socket first and then disconnect it
from the daylight therapy lamp.
App connection
You can control all of the device's functions with the "beurer LightUp" app on your smartphone.
To control the device's functions with the app on your smartphone, proceed as follows:
1. Ensure that your smartphone is connected to the Internet and that the daylight therapy lamp is switched on.
2. Download the "beurer LightUp" app from the Apple App Store (iOS) or Google Play Store (Android).
Note:
Depending on the settings for your smartphone, additional charges may be incurred for connecting to the Inter-
net or transferring data.
3. Open the "beurer LightUp" app and follow the instructions.
4. Select the "TL 100" device in the app settings. You can now use the app to control the daylight therapy lamp and
to adjust the "moodlight" (with brightness control and timer in each case).
5. The blue Bluetooth ®
with the smartphone.

6. "beurer LightUp" app features

After downloading the "beurer LightUp" app and connecting the daylight therapy lamp to a smartphone via Blue-
tooth ® (see chapter „5. Initial use"), you can control the daylight therapy lamp and the moodlight from the app.
Daylight
You can switch the daylight on and off using the app. In addition, you can also use the app to adjust the bright-
ness and set a timer for the daylight.

Moodlight

You can use the app to adjust the moodlight. The app allows you to select from ten pre-configured moodlight
settings (with brightness control and timer in each case). After activating a moodlight setting, a moodlight with
change of colour begins to light up.
The pre-configured moodlight settings can only be adjusted from the app.
Note:
The moodlight and "beurer LightUp" app must not be considered medical products. Adjustments to the daylight
function must be made on the device itself!
≥ 8.0
LED on the daylight therapy lamp will light up once the daylight therapy lamp is connected
14