Device Description; Initial Use; Usage - Beurer TL 30 Mode D'emploi

5. Device description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. Holder
4. ON/OFF button
5. Mains part connection
6. Storage slot for holder

6. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 10 cm and
30 cm between the user and the device. The lamp is most effective at this distance.
Mains connection
• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains
part described here.
• Insert the mains part into the connection provided for this purpose on the rear of the daylight therapy
lamp. The mains part must only be connected to the mains voltage that is specified on the type plate.
• After using the daylight therapy lamp, unplug the mains part from the mains socket first and then discon-
nect it from the daylight therapy lamp.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.

7. Usage

1
Remove the holder from the storage slot on the rear of the device.
2
Clip on the holder at the side. The orientation/angle of the TL 30 changes depending on where you at-
tach the holder to the device. This allows you to tailor the angle as desired. The holder can be attached
on both the long and short sides, which enables you to use the TL 30 both horizontally and vertically.
3 Switching on the lamp
 Press the On/Off button.
4
2
6
3
6
5
13
1