Operation - Beurer TL 100 Mode D'emploi

7. Operation

1 Insert the mains part into the connector.
2 Switching on the lamp
 Press the on/off button.
3 LED display/timer
The daylight therapy lamp TL 100 indicates your current treatment time with the aid of 5 LEDs.
The treatment time can be set at the following 5 levels.
The timer function is not activated when the light is switched on for the first time. The light now shines
until it is switched off again or a treatment time is set (timer = 0 min).
In order to use the timer, set the desired level from 1 to 5 using the +/− buttons. On level 1, a treatment
time of 15 minutes is set. The other levels are as follows:
Treatment time
15 minutes
30 minutes
45 minutes
90 minutes
120 minutes
The light switches off automatically after this treatment time. If you wish to deactivate the timer function,
you can press the - button until the LEDs go out.
4 Brightness adjustment
The daylight therapy lamp TL 100 has 10 brightness levels. The desired brightness level can be set
using the +/− buttons on the side – this level should be set so that it is pleasant for the eye during the
treatment. When the device is switched off, the last level that was set is saved. When the device is next
switched on, it restarts with the saved brightness level.
Note:
The device can also be used up to level 5 as a reading lamp.
5 Enjoying the light
Position yourself as close as possible to the light, at a distance of between 10 and 40 cm. You can
continue to go about your day-to-day activities during application, including reading, writing, making
telephone calls, etc.
• Keep looking directly into the light for a short period of time as it is absorbed and shows an effect via
the eyes/retina.
• Use the daylight therapy lamp as often as you like. However, the treatment is at its most effective if
you carry out the light therapy according to the prescribed time period of at least 7 successive days.
• The most effective time of day for the treatment is between 6am and 8pm and we recommend that it
is used for 2 hours per day.
• Do not look directly into the light for the entire application period as this may cause over-stimulation
of the retina.
• Start with a brief application period and gradually increase the time over the course of a week.
Note:
You may experience pain in the eyes and head after the first few applications. This pain should disappear
in further sessions as the nervous system becomes accustomed to the new stimuli.
Number of lit LEDs
1
2
3
4
5
15