Initial Use; Operation - Beurer IH 55 Mode D'emploi

Inhalateur
Masquer les pouces Voir aussi pour IH 55:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Overview of accessories
6
7
6 Adult mask
7 Children's mask
8 Mouthpiece
Storage bag

6. Initial use

Before using the device for the first time
Note
• Clean and disinfect the atomiser and accessories before
using them for the first time. See "Cleaning and disin-
fection" on page 17.
Installation
Take the device out of the packaging.
• Push the medi-
cation contain-
er (1) with mesh
atomiser (2) from
the front hori-
zontally into the
guide provided
in the housing
(4) respectively
the base of the
device so that
it audibly clicks
into place.
All manuals and user guides at all-guides.com
8
Insert the batteries
• Open the battery compartment (5) on the underside of
the device by pressing gently and pulling at the same
time, and folding open the battery compartment.
• Insert four batteries (type AA, LR6).
• Ensure that the correct
battery polarity is
observed (diagram inside
battery compartment).
• Close the battery com-
partment lid again.
Note
• When replacing the batteries, ensure that the medica-
tion container is completely empty, otherwise there is a
risk of droplets leaking out.
• As soon as the orange-coloured LED indicators (3) light
up, please change all four batteries, as the efficiency of
the nebulisation decreases significantly when the bat-
teries are low.
• With new alkaline batteries, you can operate the device
for approx. 180 minutes.
• This is sufficient for 5–9 applications with saline solution
(depending on dosage and application period).

7. Operation

1. Preparing the atomiser
• For hygiene reasons, it is essential to clean the atomiser
and the accessories after each treatment and to disin-
fect them after the last treatment of the day.
• If the therapy involves inhaling several different med-
ications one after the other, please be aware that the
atomiser must be rinsed under warm tap water follow-
ing every usage. See "Cleaning and disinfection" on
page 17.
2. Filling the atomiser
• Open the medication container
(1) by releasing the clip and fill
the medication container with
an isotonic saline solution or
pour the medication straight
in. Avoid overfilling.
16

Publicité

Table des Matières
loading

Table des Matières