Initial Use; Manual Operation - Beurer UB 190 CosyNight Mode D'emploi

5.2 Initial use

1. Starting from the foot of the bed, place the heated underblanket flat on your
mattress.
2. Use the plug-in coupling to connect the controller and heated underblanket
3. Then fit your sheet as usual so that the heated underblanket is between the mat-
tress and the sheet.
CAUTION
• Make sure that the heated underblanket is smoothed out completely flat and
that it cannot bunch up or form folds during use.
4. Insert the mains plug into a suitable socket.
Additional information UB 200
The area intended for the head is not
heated.
Guide the plug-in coupling plug through
the slot on the side section [9] and then
connect the controller to the heated
underblanket by plugging together the
plug-in coupling [8] (see fig.).
Then pull the side section over the sides
of your mattress like a fitted sheet. The
heated underblanket is designed to fit
90 x 200 cm as well as 100 x 200 cm
mattresses. Then fit your fitted sheet over
it as usual with the heated underblanket
positioned between your mattress and
the fitted sheet.

5.3. Manual operation

To switch on the heated underblanket, slide the ON/OFF/remote switch [6] on the side of the controller [1]
to the ON (I) position.
In this mode, it is possible to set individual settings for heating and switch-off times via the controller.
When switched on, the display [2] illuminates and at first displays all the segments for approx. 2 seconds.
After that, the display shows the following basic settings:
Temperature setting for body area: 0
Temperature setting for foot area:
Automatic switch-off time:
NOTE:
• The illuminance level drops after approx. 5 seconds so that illumination of the display does not disturb
your sleep during the night.
NOTE:
• This heated underblanket has a fast heating function, which allows the heated under-
blanket to heat up faster in the first 10-50 minutes (depends on the setting). For the first
15 minutes, the word "Turbo" appears on the display.
0
0
17