Troubleshooting - Dräger Interlock 5000 Notice D'utilisation

Troubleshooting

5 Troubleshooting
Display
Flow detected during Warm-Up
Blow harder! / Repeat Test
Blow softer! / Repeat Test
Blow longer! / Repeat test
Suck after Blow / Repeat test
Suck longer! / Repeat Test
Check mouthpiece / Repeat test
Please retry / Repeat test
Test failed
Low Temperature / Warm Up Handset Temperature of the handset too low.
High Temperature / Cool Down Handset Temperature of handset too high.
Service required in x days
Service lockout
Violation Reset
14
Cause
Breath sample has been blown too early.
Breath sample has been blown too soft.
Breath sample has been blown too hard.
Breath sample has been blown too short.
Breath sample is not delivered correctly by
blowing and sucking.
Breath sample has been sucked too short Repeat test sucking longer.
Mouthpiece is not correctly inserted into
handset.
During delivery of the breath sample a fault
has been detected.
The measured breath alcohol concentration
is above the set limit value.
Service interval will expire in x days.
Service interval expired.
Too many violations have been detected.
Remedy
Deliver breath sample when requested by the instrument.
Repeat test blowing harder.
Repeat test blowing softer.
Repeat test blowing longer.
Repeat test with blowing and immediately afterwards
sucking.
Insert mouthpiece correctly.
Deliver breath sample again when requested by
the instrument.
Repeat the test after waiting at least 15 minutes.
If the message appears again, the breath alcohol
concentration is above the limit value.
Detach handset and take it to a place with a moderate
temperature. Connect handset again and perform test.
Detach handset and take it to a place with a moderate
temperature. Connect handset again and perform test.
Call an authorized Dräger Interlock service centre in
due time.
Call an authorized Dräger Interlock service centre.
Call an authorized Dräger Interlock service centre in
due time.
Dräger Interlock 5000 / 7000