Product Maintenance - Tecno-gaz TYGI 350 B Manuel D'utilisation

INSTRUCTIONS FOR USE

9 PRODUCT MAINTENANCE

Maintenance of the instruments and handpieces should be carried out according to the instructions of their manufacturer.
In case of the execution of the spittoon block with the connection to the central distribution, check the cleanliness of the
advance filter (strainer) and the operation of the water hardness treatment device (according to the instructions of the
manufacturer).
Inspections during the guarantee period
During the warranty period, the user is recommended regularly invite an authorized service technician for preventive
periodical inspection in 3-month intervals.
The inspection is focused on the following:
•
check of input filters (with regard to the cleanliness of input media)
•
providing additional information and practice advice concerning the dental unit
•
check of the proper use and maintenance of the dental unit and its instruments (according to the Instructions for
Use and training)
•
check and/or adjustment of all media (input, setting of turbine pressures and the like)
•
the manufacturer determines the range of above-mentioned work to be 1 to 1,5 hours
•
authorized service technician is obliged to confirm the periodical inspection carried out in the guarantee card
Inspection and audit /revision/ after the guarantee period:
The manufacturer recommends the periodical inspection of the product to be performed in 6-month intervals by an
authorized service technician, who is to carry out the following:
•
general inspection of the dental unit and functional parts thereof,
•
check and adjustment of the working pressures of water and air,
•
check of air filter in the power block,
•
check of the integrity of the electropart and electric wiring (electrical safety).
Audit /revision/ of electrical safety
It is carried out according to the regulations of the country in which the dental unit is installed.
UM_EN_TYGI350B_2018-09_ver1.0
TYGI 350 B
43 / 49