Scaler - Tecno-gaz TYGI 350 B Manuel D'utilisation

INSTRUCTIONS FOR USE
8.1.9

Scaler

24.AUG
> 25% > 50%
P1
ENDO
DR.SMITH
After the instrument has been taken the data on its setting is displayed. Its meaning is as follows:
Instrument type
If the bargraph is inactive, it displays the type of the instrument being used. Bargraph in active condition displays
graphically an informative value of the main parameter (power output).
Button of the fast pre-selection of the scaler output.
Press the respective button to change the setting of the output to the said value. The data is not saved
automatically into the program memory.
Button for setting the scaler performance output.
Press the button to start the setting mode in which the buttons whose values can be changed are displayed
in red. Change the parameter by means of the buttons +/- .
The new value is saved temporarily (until the change of the program number) by pressing the button of
the parameter being set again or permanently into the program by means of the button
entered also directly via numerical keyboard after pressing the button
Button for the selection of a program.
Press the button to display a pop-up menu with program options.
Press the respective button to select the desired program or cancel selecting a program by means of the button ESC
To save all changed and unsaved parameters of instrument settings to program memory, just keep the button pressed
for a longer time (approximately 2 seconds)
The save is indicated by changed color of the icon (to red) and by sound signal (2 short beeps).
After the sound beeping, all data from temporal memory are written to permanent memory.
Button to assign program for switching from foot controller
UM_EN_TYGI350B_2018-09_ver1.0
12:12
SCALER
> 75%
PROGRAM 1
100
> 100%
33%
TYGI 350 B
%
TYGI 350 B
. The new value can be
34 / 49