DeWalt D55672 Guide D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Heat will ex pand fuel in the
tank which could result in
spillage and pos si ble fire
explosion.
• Combustible materials
and flammable vapors
which come into contact
with hot engine parts can
become ignited.
• Improperly stored fuel could
lead to acciden tal ignition.
Fuel im prop er ly secured
could get into the hands of
children or oth er un qual i fied
persons.
• Unattended operation
of this product could
result in personal injury
or property damage. To
reduce the risk of fire, do
not allow the compressor
to operate unattended.
• Keep maximum fuel level
1/2" (12.7 mm) be low bottom
of filler neck to allow for
expansion.
• Operate compressor in a
clean, dry, well ventilated
area a minimum of forty-
eight inches from any build-
ing, object or wall. Do not
operate unit indoors or in
any confined area.
• Operate compressor in
an open area away from
dry brush, weeds or other
combustible materials or
flammable liquid.
• Store fuel in an OSHA-
ap proved con tain er, in a
se cure location away from
work area.
• Always remain in attendance
with the product when it is
operating.
DANGER: RISK OF INJURY OR PROP ER TY DAMAGE WHEN
TRANSPORTING OR STORING
WHAT CAN HAPPEN
• Oil can leak or spill and could
result in fire or breathing
hazard; serious injury or
death can result. Oil leaks will
damage carpet, paint or other
surfaces in vehicles or trailers.
WARNING: RISK OF BURSTING
Air Tank: The air tank on your Air Compressor is designed and may be
UM coded (for units with air tanks greater than 6" (152 mm) diameter)
according to ASME Section VIII, Div. 1 rules. All pressure vessels
should be inspected once every two years. To find your state pressure
vessels inspector, look under the Division of Labor and Industries in
the government section of a phone book or call 1-800-4-D
assistance.
The following conditions could lead to a weakening of the air tank, and
result in a violent air tank explosion:
5
HOW TO PREVENT IT
• Always place compressor
on a protective mat when
transporting to protect against
damage to vehicle from leaks.
Remove compressor from
vehicle immediately upon
arrival at your destination.
Always keep compressor level
and never lie on its side.
WALT for
E

Publicité

Table des Matières
loading

Table des Matières