Reparation; Putting The Transmitter Into Operation - df models Drive & Fly HotRace XXL Notice D'utilisation

4. P

reParatIoN

.1. Putting the transmitter into operation

Control elements und functions of the transmitter
Follow the separate Operating Instructions for the remote-control transmitter and familiarise yourself with the
control elements and functions.
Pistol grip transmitter with a steering wheel for steering and pull lever for speed
1� Antenna
2� Steering wheel for steering function
3� Channel 3 (switch)
4� Trim channel 3
5� Dual rate switch
6� Battery / rechargeable battery compartment
(lower side)
7� Function switch
8� PC Link (DSC Port, rear side)
9� Charging socket (rear side)
10� Joystick for driving function
11� LCD display
12� BACK programming key
13� END programming key
14� Bind button
15� ENTER programming key
SELECT programming key (turn left/right)
16� Trim control channel 2 driving function (up)
17� Trim control channel 2 driving function (down)
18� Trim control channel 1 steering function (left)
19� Trim control channel 1 steering function (right)
Steering wheel for steering function (2)
Depending on the direction in which the wheel is rotated (channel 1) the servo arm of the connected servo steering moves
to the right or left. And the wheels are driven in to the right or left by the corresponding linkages.
Dual Rate Switch Steer Angle (5)
The servo travel of the steering servo can be set within a range of 0% to 100%. This setting affects both the steering direc-
tions, to the right and left equally.
Function switch (7)
The transmitter can be switched on or off using the function switch.
PC Link (8)
Via the PC link, the remote-control transmitter can also be used for training on a PC. Control signals are transmitted from
your transmitter to the PC directly via the connection cable. This way, using an appropriate driving simulation program,
valuable experience can be gained while going easy on your equipment.
Charging socket (9)
The function switch should be in the "OFF" position before you start charging!
Never try to charge dry batteries.
Joystick for driving function (10)
The signal of the control lever (channel 2) controls the speed controller / the accelerator servo /brake servo and is moved to
the front for braking and to the back for accelerating.
LCD Display (11)
When you switch the transmitter on, the display lights up and shows the starting window. When the programming and
input keys have not been used a long while, the display goes into power saving mode, and the backlighting goes off.
The BACK (12) programming key
The BACK key will take you from the programming mode back to the starting window.
The END (13) programming key
Use the END key to end the input for a parameter and move to the next adjustable parameter within the same menu level.
Repeatedly pressing the END key will scroll you cyclically through the parameters of a menu item.
1
11
7
5
4
10
3
6
-  -
9
8
12
2
19 18 17
14 13
15
16
3402/V1/0211