Preparation With Coffee Capsules Brtp-Brtpn; Useful Tips; Steam - La Pavoni BARETTO Mode D'emploi

English
(11). When the desired amount of coffee is in the cup, turn off the switch (14) to stop the coffee but do not
remove the portafilter.
Warning: the coffee emerges from the spout of the portafilter at a temperature of
75-85°C. Exercise caution to avoid burns.
Remove the cups from the cup rest and serve immediately.
To prepare other cups of coffee, slowly remove the filter-holder from the coffee group by turning it to the left until
it dislodges. Exercise care because the filter-holder will still be hot and some hot water will remain in the coffee
grounds. Some water will drip from the coffee group after the filter-holder is removed due to residual water
pressure in the system.
Remove the grounds from the filter and repeat the procedure as described above.
The machine is equipped with an automatic anti-drip valve (only BRTE model) to eliminate most of the residual
coffee that might drip from the coffee head. Nevertheless, some dripping from the wet grounds
in the portafilter is normal.
11.3 – COFFEE PREPARATION (BRTP-BRTPN)
• The special pressurized filter holder ensures the preparation of a good and
creamy genuine espresso coffee.
• Insert the filter holder under the boiler group (5) and turn it from left to right
until it locks, in order to pre-heat it. Leave the filter holder handle (Fig. E).
• The handle will now automatically turn slightly back to the left. This little
movement ensures the perfect operation of the filter holder, for a long time.
• Check the water level in the tank is enough for the amount of coffee wanted.
• Push the main switch (13).
• Wait until the warning light (15a) turns on.
• Now the machine has reached the right temperature to pump water.
• Remove the filter holder from the boiler group (5) and insert the big filter for
coffee into the filter holder.
• Fill the filter with one or two measuring spoons of ground coffee according
to the number of coffees to be prepared (fig. G). about 1 measure = 1 coffee
about 2 measures = 2 coffees
• The quantity and pressing of the coffee powder directly affect the quality
and flavour of the espresso.
• Slightly press the coffee with the measuring spoon, then clean the filter
holder brim of any coffee residues (Fig. H).
• Install the filter holder in the boiler group (5), as described above.
• Put two pre-heated cups under the filter holder.
• Push the coffee switch (14). When the required amount of coffee has run
into the cups, turn the coffee switch off.
• After having made coffee, remove the filter holder and empty the coffee
grounds. Then, rinse the filterholder under running water
28
11.4 – PREPARATION WITH COFFEE CAPSULES BRTP-BRTPN
The pressurized filter holder may also be used to prepare the espresso with
coffee capsules, as follows:
• Remove the filter from the filter holder.
• Place the insert for coffee capsules into the filter holder, the face with four
fins on the top (Fig. I).
• Install the small filter for coffee capsules into the filter holder. In order to
obtain a good hot coffee from the first cup, it is recommended to pre-heat the
filter holder, filter and cups.
• Insert the filter holder under the boiler group (5) and turn it from left to right
untilit locks, in order to pre-heat it. Leave the filter holder handle (Fig. E).
• The handle will now automatically turn slightly back to the left. This little
movement ensures the perfect operation of the filter holder, for a long time.
• Check the water level in the tank is enough for the amount of coffee wanted.
Push the main switch (13).
• Wait until the warning light (15a) turns on.
• Now the machine has reached the right temperature to prepare the espresso
with coffee capsules.
• Remove the filter holder from the boiler group (5), swinging it to the left.
• Put a coffee capsule into the special filter. Handle the capsule with care, to
avoid damaging it.
• Insert the filter holder into the boiler group (5) and turn it from left to right
until it locks.
• Put a cup under the filter holder. Push the coffee switch (14).
• When the required amount of coffee has run into the cup, turn the coffee
switch (14) off.
• Once the preparation is over, remove the filter holder and discard the coffee
capsule.
11.5 – USEFUL TIPS
a) It is not necessary to wash the filters (9 and 10) after every single use. Make sure that the holes are not
obstructed.
b) For a better result, we suggest warming the cups on the cupwarmer (2) which works by machine on only.
11.6 – STEAM
Steam can be used for frothing the milk to obtain cappuccinos or to warm up beverages.
Attention! Burn risk: at the beginning there might be hot water sprinkling. The hot
water tube might reach high temperatures: do not touch it with hands.
Version the turbo cappuccino maker
1. Prepare your espresso in big mugs as already specified.
2. Once the machine is ready to make the coffee, position the steam nozzle on the tray (7), open the hot water/
steam knob (4) for a few seconds so that the few drops of water inside the nozzle come out; after a few second
you will get only steam.
3. Close the hot water/steam knob (4).
4. Set the steam lever (15) on the position "I".
Then, rinse the filterholder under
29
English
running water.