Using The Machine; Preparing And Dispensing Coffee - La Pavoni LPSGEV02 Manuel D'utilisation

PID temperature controllers regulate
the boiler temperature.
The PID temperature controller (27)
is factory set to 122°C. To adjust the
setting proceed as follows (Fig. 6):
• press the
button
as "PRG" appears on the display, press
the button ;
• when the temperature of the boiler
appears on the display, press the
and buttons to increase
or decrease the temperature from a
minimum of 80°C to a maximum of
133°C.
• 3 seconds after having pressed the last
button, the value is memorized and
the display indicates the temperature.

5. USING THE MACHINE

5–1. PREPARING AND DISPENSING
COFFEE
Once you have carried out the
operations described in section 4.1-4.2,
the machine is ready for use.
Do not cover the cup-warming
shelf with fabrics, felt etc.
• Place the required filter (20-21) into
the filter holder (12).
• Fill the filter with the required amount
of coffee for 1 or 2 cups (7 g - 16 g)
according to the filter selected (20-21).
• Level the coffee and compact it using
the tamper (18). Remove any coffee
residues from the edge of the filter
using the palm of your hand and insert
the filter holder into the group head
(11), moving it towards the right to
secure it.
• Place the cups under the spouts and
start to dispense coffee using the
group head control lever (15). The
coffee is dispensed by moving the
group head lever (15) located on the
control panel upwards.
• Once the required amount of coffee
has been dispensed, move the group
head lever (15) down to stop delivery.
• To dispense additional cups of coffee,
as soon
remove the filter holder (12) from the
group head by moving it towards the
left, empty the coffee grounds and
repeat the steps described above.
23
Do not touch the group heads or
the steam and hot water nozzles
when the machine is in operation
and do not place your hands
under the groups heads or pipes
during delivery in order to avoid
possible scalding.
When the machine is new, the
filter holder may not be aligned
(perpendicular to the machine) as
shown in Figure 5. However, this
does not prevent the machine
from working properly. After
being used for a short time, the
filter holder will gradually become
settled in the correct position.
G = Position of the closed filter
holder when the machine is new
H = Position of the closed filter
holder after the machine has
been in use for a short time.
• Coffee should be ground
just before it is used. Once
ground, coffee loses its flavour
very quickly. If the coffee is too
coarsely ground, the coffee will be
light coloured and weak without
froth and if the coffee is too finely
ground the espresso will be dark
and strong with little froth.
• Warm cups help maintain the
coffee at the right temperature.
We therefore recommended that
before using them, you place the
cups on the cup warmer shelf (3),