Sony DSR-45 Mode D'emploi page 53

Control signal connections
The following shows an example of the control signal
connections needed to enable the editing controller to
control all other A/B roll editing system devices.
Editing controller
MIXER
PLAYER 2
RECORDER
SWITCHER
Audio mixer
To control the unit from an editing controller, set the
REMOTE/LOCAL switch of this unit to REMOTE.
Furthermore, if you use an RS-422A connection, set the
remote selector of this unit to RS-422A.
a) Use an optional 9-pin remote control cable.
PLAYER 1 9-pin remote control cable
9-pin remote control cable
9-pin remote control cable
EDITOR
Switcher
DSR-45/45P (Player 1)
a)
a)
a)
REMOTE
Recorder
Chapter 3 Using the Unit as a Player in an Editing System
RS-422A
REMOTE
Player 2
53
(GB)