Connections For A Cut Editing System - Sony DSR-45 Mode D'emploi

Connections for a Cut Editing System

The following figure shows a cut editing system
configuration that uses this unit as the player.
For details of connecting devices other than the DSR-45/
45P, refer to the instruction manual of each device.
S VIDEO OUT
VIDEO OUT
COMPONENT OUT
DSR-45/45P (player)
VIDEO IN
REF.IN
1
2
REF.VIDEO
OUT
PLAYER REF.VIDEO IN
Editing controller
Connect one of the following as a video cable:
video cable (3BNC y 3BNC), S-video cable, or
75 Ω coaxial cable.
Note
Use a recorder equipped with a synchronization
function.
MONITOR VIDEO
MONITOR
AUDIO
AUDIO OUT CH-4
AUDIO OUT CH-3
AUDIO OUT CH-2
AUDIO OUT CH-1
RS-422A
REF.VIDEO
OUT
Reference
video signal
generator
REF.VIDEO OUT
1
RECORDER
Note
The preroll time of the setting on the editing controller
is required to be more than five seconds.
S VIDEO IN
5
VIDEO IN
1
Y, R-Y, B-Y IN
1
Video
input
3
Source video
Audio
monitor
input
3
AUDIO IN CH-4
4
AUDIO IN CH-3
4
AUDIO IN CH-2
4
AUDIO IN CH-1
4
Recorder
REF.VIDEO
IN
1
MONITOR
AUDIO
Audio input
2
1 75 Ω coaxial cable (not supplied)
2 9-pin remote control cable (not supplied)
3 Phono jack cable (not supplied)
4 Cable with XLR connectors (not supplied)
5 S-video cable (not supplied)
Chapter 3 Using the Unit as a Player in an Editing System
MONITOR REMOTE
VIDEO OUT
3 1
Video input
Main video
monitor
49
(GB)