Sony DSR-45 Mode D'emploi page 67

5
Set EXT SYNC on the VIDEO SET menu to ON,
then play back a tape on this unit.
6
Press the A channel button on the vectorscope.
The vectorscope displays the sync phase and
subcarrier phase (composite signals only) of the
signal from this unit.
7
Adjust the SYNC control using H PHASE on the
VIDEO SET menu for rough adjustment, then
adjust H PHASE F for fine adjustment, so that the
output from this unit on channel (A) is in correct
phase alignment with the black burst signal on
channel (B).
8
Adjust the SC control using SC PHASE on the
VIDEO SET menu for rough adjustment, then
adjust SC PHASE F for fine adjustment, so that the
output from this unit on channel (A) is in correct
phase alignment with the black burst signal on
channel (B).
(for NTSC)
This indicator moves as you
adjust the H PHASE or H
PHASE F menu.
Adjust the sync and subcarrier phase of the output
signal from this unit.
(for PAL)
This indicator
moves as you
adjust the H
PHASE or H
PHASE F menu.
Adjust the sync and subcarrier phase of the output
signal from this unit.
Note
When component signals are used, the subcarrier
phase indicator does not appear.
This indicator moves
as you adjust the SC
PHASE or SC
PHASE F menu.
This indicator
moves as you
adjust the SC
PHASE or SC
PHASE F menu.
Chapter 4 Setting the Time Code and Adjusting the Video Signals
67
(GB)