Sony DSR-45 Mode D'emploi page 91

Submenu
Icon/Menu
(page)
VTR SET DUPLICATE
VTR
(page 69 (GB))
DV EE OUT
(page 42 (GB))
STILL TIME
FROM STILL Selects the tape protection mode to which the unit switches after the still mode continues for
Setting
Switches the duplicate mode.
AUTOq : Starts duplication after rewinding the tape to the beginning in the player
and recorder. (The cassette memory is also duplicated.)
AUTOq: Starts duplication after rewinding the tape to the beginning in the player and
recorder. (The cassette memory is not duplicated.)
MANUALq: Duplicates the tape from any point. (The cassette memory is not
duplicated.)
Note
You cannot change the setting of this item during duplication.
Selects the output from the DV jack in the EE mode.
OFF : Outputs only the playback video and audio signals from the DV jack.
ON: Outputs the selected analog input signals from the DV jack.
Note
When you connect a computer to the DV jack, depending on your computer software, the
selected analog input signals may be output to the computer even if this item is set to OFF.
Selects the length of time that elapses before switching to the tape protection mode from
the still mode.
30 SEC : 30 seconds
1 MIN: 1 minute
2 MIN: 2 minutes
3 MIN: 3 minutes
5 MIN: 5 minutes
Notes
• If the unit is left in playback pause mode for a long time, the tape or the video heads may
be damaged or the video heads may become clogged. Select the shortest time possible
—particularly when using a Mini-DV cassette that is longer than 60 minutes, select 30
SEC or 1 MIN.
• If you change the setting of this item while the unit is in the playback pause mode, the first
tape protection mode change uses the time setting from before the settings were changed.
From the second tape protection mode change, the new time setting is used.
the time interval set in STILL TIME.
STOP : Stops the tape.
STEP FWD: Forwards one frame.
Chapter 6 Adjusting and Setting Through Menus
91
(GB)