Sony DSR-45 Mode D'emploi page 60

Setting the Time Code and User Bits
3
Press the J/j buttons to select UB PRESET, then
press the EXEC button.
The following menu appears.
TC ⁄ UB SET
TC PRESET
TC
UB PRESET 00 00 00 00
RMT
TC ⁄ UB IN
CM
DV IN TC RESET
DISP
TC MAKE PRESET
V
TC RUN RETURN
A
TC FORMAT
VTR
JOG TC OUT
ETC
RETURN
4
Press the J/j buttons to select PRESET, then
press the EXEC button.
The following menu appears.
TC ⁄ UB SET
TC PRESET O O O O
TC
UB PRESET 00 00 00 00
RMT
TC ⁄ UB IN o o o o
CM
DV IN TC SET
DISP
TC MAKE CANCEL
V
TC RUN
A
TC FORMAT
VTR
JOG TC OUT
ETC
RETURN
5
Set the first two digits. Press the J/j buttons to
select the number, then press the EXEC button.
6
Repeat step 5 to set the other digits.
7
Press the J/j buttons to select SET, then press the
EXEC button.
The user bits are set and the menu display returns
to that of step 2.
8
Press the J/j buttons to select
press the EXEC button.
The menu display returns to that of step 1.
To cancel the user bits setting
Select CANCEL in step 7, then press the EXEC
button.
To reset the user bits
Select RESET in step 4, then press the EXEC button.
60
(GB) Chapter 4 Setting the Time Code and Adjusting the Video Signals
To select the time code/user bits to be
recorded on the tape
You can set the time code and user bits to be recorded
on the tape by setting TC/UB IN on the TC/UB SET
menu.
INTERNAL: Uses the internal time code/user bits.
TC&UB EXT: Uses the external time code/user bits.
TC EXT: Uses the external time code and internal
UB EXT: Uses the internal time code and external
Notes
• This unit has a DV jack. The time code input or
output is different when you connect the unit to an
external device via this DV jack or via another input/
output connector.
For details, see "DSR-45/45P time codes" on page 63
(GB).
• The time code output from this unit has some
restrictions.
For details, see "Notes on the Time Codes" on page 64
(GB).
To select the time code to be recorded
when DV signals are recorded in DVCAM
format
Set DV IN TC on the TC/UB SET menu to select
whether to record the internal time code or an external
one.
INTERNAL: Records the time code internally
EXTERNAL: Records the time code with video and
RETURN, then
Notes
• When this item is set to EXTERNAL, the setting of
TC/UB IN on the TC/UB SET menu turns to invalid.
The time code input via the DV jack and the user bits
set in UB PRESET are recorded.
• When you set REC MODE on the VTR SET menu to
DV SP, this item cannot be used. Even if this item is
set to EXTERNAL, when you set REC MODE on the
VTR SET menu to DV SP, the setting becomes
invalid and the unit records the internal time code.
user bits.
user bits.
generated.
audio signals input via the DV jack.