Audio Dubbing; Connection Of External Devices - Sony DSR-45 Mode D'emploi

Audio Dubbing

Audio Dubbing
You can record just sound on a recorded tape.
(Audio dubbing)
Note
You can dub the sound onto a DVCAM-formatted
tape (recorded) in the 32 kHz audio mode (4-channel/
12 bits). You cannot dub the sound on a tape in the 48
kHz audio mode (2-channel/16 bits). If the audio mode
of the recorded tape is 32 kHz, you can dub the sound
regardless of the AUDIO MODE setting on the
AUDIO SET menu.
For details on "AUDIO MODE," see "AUDIO SET menu"
on page 88 (GB).
DSR-45/45P
(front panel)
Headphones
CH-
1/2
MIN
PHONES
Sound source
Selecting the input channels for audio
dubbing
You can dub the sound in the following channel
combinations: channels 1/2 or channels 3/4.
Set AUDIO DUB on the AUDIO SET menu to select
the input channels for audio dubbing.
CH1,2: Selects the channel 1/2 combination.
CH3,4: Selects the channel 3/4 combination.
OFF: Disables audio dubbing.
74
(GB) Chapter 5 Duplication and Audio Dubbing
1
CH-
3/4
DSR-45/45P
MAX
(rear panel)
Audio output
AUDIO IN
CH-1, CH-2 or
CH-3, CH-4

Connection of external devices

The following shows an example of a basic connection
for audio dubbing.
Video input
MONITOR VIDEO
MONITOR AUDIO
Audio input
Note
You cannot dub sound in the following channel
combinations:
• Channels 1 to 4 simultaneously
• Only one channel
• Three channels simultaneously (excluding one
channel)
• Channel 1/3, channel 2/4, channel 1/4 and channel
2/3 combinations
Monitor