Lighting The Fire; Adding Fuel / Heating At Nominal Thermal Output - HASE Luno Manuel D'utilisation

7. Lighting the Fire

The firing up phase should be as short as possible,
since higher emissions can occur during this phase.
The slider settings described in Table 1 are recom-
mendations that were determined under confor-
mance testing conditions, in compliance with the
relevant standard. Depending on the weather con-
ditions and the draught capability of your chimney,
accordingly adjust the slider positions for your Luno
to the local conditions.
NOTE!
The Luno may only be operated when the
fire box door is closed; the fire box door
may only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other flamma-
ble fluids to light the stove.
Lighting the Fire
Procedure Position of Control
Elements
Completely open second- Pull air slider all the way
ary air. out.
Pile up any remaining ash
and unburned charcoal
into the centre of the
combustion chamber.
Close fire grate. Push in fire grate slider.
Place 4-6 small pieces of
wood with an approx. Ø
of 3-6 cm and max. 2 kg
in the middle of the burn-
ing chamber. Layer these
cross-wise on top of each
other. Place approx. 0.5
Delhi
kg of wood shavings on
top as a firelighter.
Light the kindling/ignition
material.
Tab. 1
8. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the fire when the
flames from the previous burning off phase have just
gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust secondary air. Set air slider between
position 1 & 2.
Close fire grate. Push in fire grate slider.
Add two logs weighing
approx. 1.3 kg in total.
Place logs with the end to
the front of fire box. Only
add a single layer of fuel.
Tab. 2
39