Initial Operation; Lighting The Fire - HASE Ottawa B.11 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

When you close the slider (A), the majority of the warm air
fl ows to the heat retaining block and is gradually dispersed
back into the room as cosy warmth.
fi g. 7
7 .

Initial Operation

NOTE!
During shipment, condensation moisture can
accumulate in the stove's interior, which may
possibly lead to the appearance of
condensation or water on the stove or fl ue
pipes. Please dry off these damp areas imme
diately.
The surface of your stove was treated in a sandblasting ma-
chine before applying the colour coating. Despite careful and
A
thorough inspection, there may still be some residual material
in the stove body, which can fall out when your stove is being
installed.
NOTE!
To prevent any damage, please immediately
vacuum up these small steel pellets with a
vacuum cleaner.
The fi rst time a stove is operated, the heat development
causes the emission of volatile components from the coating,
sealing strips and lubricants, and smoke and odours can occur.
At a higher combustion temperature, this one-time process
can take between 4 to 5 hours.
To achieve this higher combustion temperature, please incre-
ase the fuel quantity recommended
in Section 9, „Adding Fuel/ Heating with Nominal Thermal
Output", by approximately 25%.
CAUTION!
To prevent adverse effects on health, nobody
should stay in the room(s) during this process
unless absolutely necessary. Make sure the
room is well-ventilated and open the windows
and outside doors. If needed, use a fan for
faster air circulation.
If the maximum temperature is not reached during the fi rst
heating operation, you may notice an odour for a short period
of time the next time the stove is used as well.
8.

Lighting the Fire

The fi ring up phase should be as short as possible, since high-
er emissions can occur during this phase.
The slider settings described in Table 1 (see fi gure on the right)
are recommendations that were determined under confor-
mance testing conditions, in compliance with the relevant
standard. Depending on the weather conditions and the drau-
ght capability of your chimney, accordingly adjust the slider
positions for your Ottawa to the local conditions.
CAUTION!
The Ottawa may only be operated when the
fi re box door is closed; the fi re box door may
only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other fl ammable
fl uids to light the stove.
37

Publicité

Table des Matières
loading

Table des Matières