Initial Operation - HASE OSAKA Manuel D'utilisation

A
CAUTION: HOT SURFACES
The stove is equipped with a rotating
console. Turning the stove whilst heating
can result in burns:
► Never turn the stove whilst heating.
WARNING: FIRE HAZARD
Flammable objects (e.g. furniture) within the
radiation area of the stove can catch fire:
► Flammable materials, e.g. furniture, must
not be located within the radiation range
of the stove at the set radiation area
(Fig. 7 and Fig. 8).
Fig. 6

7. Initial Operation

NOTE!
During shipment, condensation moisture
can accumulate in the stove's interior,
which may possibly lead to the appearance
of condensation or water on the stove or
flue pipes. Please dry off these damp areas
immediately.
The surface of your stove was treated in a
sandblasting machine before applying the colour
coating. Despite careful and thorough inspection,
there may still be some residual material in the
Fig. 7
stove body, which can fall out when your stove is
being installed.
NOTE!
To prevent any damage, please immedi-
ately vacuum up these small steel pellets
with a vacuum cleaner.
The first time a stove is operated, the heat
development causes the emission of volatile
components from the coating, sealing strips and
lubricants, and smoke and odours can occur.
At a higher combustion temperature, this one-time
process can take between 4 to 5 hours.
To achieve this higher combustion temperature,
please increase the fuel quantity recommended
Fig. 8
in Section 9, „Adding Fuel / Heating with Nominal
Thermal Output", by approximately 25%.
en
41