Initial Operation; Safety Notes; Switching On The Regulator; Using The Iq Technology - HASE LHASAiQ Mode D'emploi

6 Initial operation

6.1 Safety notes

CAUTION: INITIAL OPERATION
The first time a stove is operated, the heat generated causes volatile
components to be released from the coating, sealing strips and the
lubricants as well as smoke and odours:
► Do not stay longer in the affected rooms than necessary.
► Open windows and doors to ensure adequate ventilation.
► If necessary, use a fan for fast air exchange.
► Only operate the stove with the firebox door closed.
► The firebox door may be opened to add fuel during operation.
WARNING: KINDLING
Improper use of kindling (petrol, spirits or other flammable liquids) can
damage your stove and result in burns due to explosive flames:
► Never use petrol, spirits or other flammable liquids.
► Only use the type of kindling specified in the operating
instructions.
WARNING: ELECTRIC SHOCK
Connecting the controller under the stove to a 230 Volt mains socket can
result in electric shock due to contact with the stove:
► Do not connect your stove to a 230 Volt mains socket under the
stove.
► The connection under the stove must be a USB connection
with max. 5 Volt.

6.2 Switching on the regulator

The controller detects all operating states and automatically configures the
required settings.
The stove cannot be operated manually without the controller.
Switching on the controller:
► Connect the USB-C cable to the socket on the stove
and the mains plug (Figure 8).
► Connect the mains plug to the mains (Figure 8).
► Open the service door.
► Set the switch on the control panel to "On" (Figure 9).
When the power light lights up blue, the controller is ready.
9 Close the service door.
NOTE: MAINS PLUG AND USB-C CABLE
Using a mains plug or USB-C cable not included with your stove may
damage the electronics:
► Always use the included HASE mains plug and USB-C
cable to connect the controller to the mains.
INFO: CALIBRATION PROCEDURE
Every time the controller on the control panel is switched on, the air flaps will
be calibrated and tested. During this process the LED will flash for
approx. 1 min.
INFO: SWITCHING THE CONTROLLER OFF
If the stove will not be used, the controller on the control panel can be
switched off to save electricity.

6.3 Using the iQ technology

6.3.1 WiFi

Using the iQ technology with the iQ app requires connecting it to the WiFi
of your router with your smartphone, laptop or tablet (Manual: www.hase.de).
The app cannot be used outside WiFi range.

6.3.2 iQ app

The iQ technology can be synced with the iQ app to access various functions
from your smartphone, laptop or tablet.
The iQ app for Android and iOS can be downloaded from the respective
store and installed on your device.

6.4 Heating with iQ technology

iQ technology detects all operating states and automatically configures all of
the required settings.
The stove cannot be operated manually without the controller.
Fig. 8
A
A
en
Fig. 9
91