Gravel Arrangement - Propane; Initial Operation; Servicing Instructions; Annual Maintenance - HASE Modena Gas Mode D'emploi

2.16 Gravel Arrangement - Propane

1 bag of Gravel
Procedure: First place the Mat on top of the
Burner and place the grate plate on top of the Mat
and Burner.
Scatter the contents on the Bag of Gravels over
the top of the Mat and Grate area, leaving the
Gas ports clear.
Care is needed so that none of the Gravels enter
the Pilot shield, this area must be kept clear and the cross lighting to the main burner not
impinged (Abb. 30).

2.17 Initial Operation

A soundness test MUST be made before the installed stove is left with the customer.
Ensure that the fi re is burning at full rate for a minimum of 5 minutes to warm the fl ue.
If there are problems, the chimney/fl ue may require attention. Isolate the stove and seek
expert advice.
The stove will produce an odour and/or smoke for the fi rst few hours of use. Please ventilate
the room.
When the stove is operated for the fi rst time, additional white residue may form on the
ceramic glass panels in the interior. This residue is non-toxic and can be removed with a
conventional glass cleaner.
70
All manuals and user guides at all-guides.com
Fig. 30
3

Servicing Instructions

3.1

Annual maintenance

The following outlines only the minimum work that should be performed on an annual basis.
This service work, like any other work on the appliance, must only be done by a qualifi ed
and competent engineer.
• Open the door and remove all ceramics.
• Remove mat from top of burner.
• Remove any debris from the top of the burner using a vacuum cleaner and brush.
• Inspect the burner unit.
• Perform an ignition check.
• Perform a fl ame failure check
• There should be no need to service the burner. If however this is required, then the
engineer should check the setting pressure at inlet to burner; the correct pressure is
shown at the front of the manual.
• Brush off and replace ceramic arrangement as earlier in this manual, replacing any broken
or damaged pieces.
• Check all seal on door (including glass) and replace the Door.
• Check the installation for gas leaks.
• Check fl ue for clearance of products of combustion.
If any parts need to be replaced use only genuine Hase parts, non-standard parts will
invalidate the guarantee and may be dangerous.