Setting The Timer; Igniting The Stove; Extinguishing The Appliance Fully - HASE Modena Gas Mode D'emploi

4.7

Setting the Timer

Press the SET button until the TIMER mode is displayed. Hold the SET button until the timer
display starts fl ashing. Set the start time for heating period 1 (P1) by pressing ▲ to set the
hour and ▼ to set the minutes.
Press the SET button again to set the end time for heating period 1 (P1).
Pressing the SET button once again lets you set the times for heating period 2 (P2-P2).
If you only want to program one heating period, simply enter identical times for P1/P1
and P2/P2.
Once all times are set, press OFF to store the values.
All manuals and user guides at all-guides.com
4.8
Prior to starting the ignition process, the left con-
trol knob (a) must be turned to the "OFF" positi-
on and the right control knob (b) must be turned
to the "ON" position. Furthermore, the ON/OFF
switch must be activated.
Simultaneously press the OFF and ▲ buttons of
the receiver for ignition.
An acoustic signal indicates that the start sequence has begun.
The electronic system then checks that the main gas is fl owing and ignites the main burner;
this may take up to 20 seconds.
You may need to repeat the ignition sequence several times.
Please note:
Once the pilot fl ame ignites, the motor automatically sets the main burner to maximum
fl ame height.
Using the remote control, you now can operate the stove in one of the modes described
above.
4.9
From any heat setting, press the OFF button for a few seconds. This will cause the burner
to fully extinguish.
The system has a safety interlock which will not allow the Ignition until the Interlock rests
(this may take a few minutes).

Igniting the Stove

Extinguishing the Appliance Fully

c
a
b
73