Remote Control With Climate Control; Setting The Display; Setting The Current Time; Modes - HASE Modena Gas Mode D'emploi

4.1

Remote Control with Climate Control

4.2

Setting the Display

Simultaneously pressing OFF and ▼ switches from the Fahren-
heit (°F)/12-hour clock to the Celsius (°C)/24-hour clock and vice
versa.
4.3

Setting the Current Time

After inserting the battery or by simultaneously pressing ▲ and
▼, the display starts fl ashing. You are now in set mode.
In set mode, press ▲ to set the hour and ▼ to set the minutes.
Wait for a short time or press OFF to return immediately to ma-
nual mode.
4.4

Modes

MAN: Mode for manual fl ame height adjustment
(stove in standby mode).
Press ▲ to ignite the main burner or increase the fl ame height. Press ▼ to
decrease the fl ame height or activate standby mode (permanent pilot). To
incrementally increase or decrease the fl ame height, repeatedly lightly tap
the ▲ or ▼ button.
The "Send" icon appears in the upper right corner of
the display when either button is pressed.
 TEMP: Daytime temperature control mode (automatic)
 TEMP:
Nighttime temperature control mode (automatic)
A sensor in the transmitter measures the room temperature.
The receiver then compares the room temperature to the preset
temperature and adjusts the fl ame height as necessary.
72
All manuals and user guides at all-guides.com
TIMER: Timer mode
During heating periods P1 and P2, the temperature is controlled in the
same manner as in automatic mode.
If the timer switches to  (heating cycle off), the actuating motor sets
the valve to standby (permanent pilot) and the temperature control is
deactivated, which minimises battery consumption.
In order to maintain automatic temperature control in the  mode
as well, the  temperature must be set to 4°C or higher.
4.5

Switching Modes

Pressing the SET button cycles through the various modes in the following sequence:
MAN   TEMP   TEMP  TIMER and back to MAN
From any mode, press ▲ or ▼ to return immediately to manual mode.
4.6

Setting the Temperature

Press the SET button until the  TEMP or  TEMP modes are displayed.
Hold the SET button until the temperature display starts fl ashing. Press ▲ or ▼ to set the
desired temperature.