Vetus BOW22024 Manuel D'utilisation Et Instructions D'installation page 19

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Electrical installation
Make sure that no other electrical parts come loose
when connecting the electric cables.
Check all electrical connections after 14 days.
Electrical parts (such as bolts and nuts) may come
loose as a result of fluctuations in temperature.
Check that the voltage, recorded on the motor type plate, is in
agreement with the vessel's circuit voltage. Position the battery
or batteries as close as possible to the bow thruster; the main
power supply cables can then be short, which reduces the volt-
age drop as much as possible.
Connect the main power supply cables.
Fit the control panel next to the steering position. There must be
at least 50 mm space behind the panel.
Fit the control cable between the bow thruster and the control
panel through the vessel and connect the jack connections
together.
If it is necessary to cut the intermediate cable and reconnect it
take care to ensure the correct colours are connected together.
N.B: The colours of the wire cores in the intermediate cable may
differ from the wire core colours as used on the bow thruster
motor and on the control panel!
Operation manual and installation instructions Bow thruster 220 kgf, ø 300 mm
A time-delay (BPTD) can be
fitted
between
the
bow
thruster motor and the oper-
ating panel switch. This
allows the electric motor to
come to a stop when a switch
is made from port to star-
board (or vice-versa) in one
movement.
If there are two steering positions, the second control panel can
be connected to the first one.
If it is found during test running that the thrust direction does not
correspond with the direction switch on the control panel then
the blue (no. 1) and the white (no. 4) wires on the relay must be
interchanged.
WARNING
Do NOT test the bow thruster while the ship is out of
water, unless you are certain that everyone is at a safe
distance from the thrust tube.
Never allow the bow thruster to run for longer than 5
seconds with the ship out of water.
ENGLISH
17
020529.03

Publicité

Table des Matières
loading

Table des Matières