Arktic 233238 Mode D'emploi page 9

Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
Problems
The appliance does not
start cooling after con-
nect to electrical pow-
er supply.
Cooling is not enough.
Too much noise
Possible cause
Thermal cut-out activated
The compressor is defective.
The power plug is connected correctly
with the power supply outlet.
The appliance is under strong sunlight
radiation or close to a heat source.
The doors are not properly closed or
the sealing gasket is defective.
Too much food is placed inside the
appliance.
Surrounding ventilation is insufficient.
The appliance is not placed horizon-
tally.
The appliance touches surrounding
wall or other objects.
There are some loose parts inside the
appliance.
still unable to solve the problem, please contact the
supplier/service provider.
Possible solution
Contact with the supplier/service pro-
vider for repair.
Check the connection and make sure
all the connections are correctly con-
nected.
Move the appliance a new location to
avoid direct sunlight.
Close the doors properly.
Place less food inside the appliance.
Check that if sufficient ventilation is
provided by allowing at least 10cm
away from other objects or wall.
Check to make sure the appliance is
placed horizontally.
Check to make sure that at least
10cm away from other objects or wall.
Contact with the supplier/service pro-
vider for repair.
EN
9