Panasonic EYFLA4A Instructions D'utilisation page 13

Snug point detection level guidelines
Display
L1 (Use for work characterized by low loads
before the snug point is reached.)
L (Use for work characterized by high
loads before the snug point is reached.)
Tightening Torque Chart (for Reference Use)
The values illustrated on this chart were mea-
sured under the conditions described below
and are provided for reference purposes.
Actual tightening torque varies with ambient
conditions (the particular bolt being tightened,
hardware being used, method of holding the
bolt in place, etc.).
N m
140
120
100
EYFMA1(M12)
80
60
40
EYFLA6(M8)
20
EYFLA5(M6)
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30
Measurement conditions
• Temperature: Room temperature (0°C/68°F)
Using the Interval Set
• The interval set operates to prevent the tool
from operating after it automatically stops as
a result of the torque control function, even if
the switch is engaged.
1. Set the tool to configuration mode.
(See page 11.)
. Press the interval set button.
• The control panel will begin flashing.
Display: The number 0 flashes on and off.
Battery indication lamp: The middle bar
of the battery flashes on and off.
Snug point detection level
Low
High
EYFMA1(M14)
EYFLA6(M10)
EYFMA1(M10)
EYFLA5(M8)
EYFLA4(M8)
EYFLA4(M6)
Applications (reference)
• Tightening bolts in materials that are
easily cracked or deformed, etc.
• Tightening bolts in materials with mis-
aligned holes, etc.
• Tightening self-tapping screws, etc.
Display
3. Press the
desired time.
Buttons
4. Press the OK button to accept the select-
ed setting.
• The control panel will stop flashing and
light up, and the torque clutch setting
will be displayed.
CAUTION:
• Be sure to verify the new value after
changing the setting.
- 13 -
Battery indication lamp
and buttons to set the
Display Seconds
30
1
0
3
0.1
Off