Panasonic EYFLA4A Instructions D'utilisation page 11

) Other
• Bit and socket condition: Material,
amount of play, etc.
• Use of a universal joint or socket
adapter
• User: Manner in which the tool is
applied to the bolt, strength with which
the tool is held, manner in which the
tool's switch is engaged
• Condition of object being tightened: Ma-
terial, seating surface finish
Setting the tool to configuration mode
1. Turn off the control panel.
• If the control panel is on, remove and
then reinsert the battery pack.
. Engage the switch while pushing the
button and then release both the
ton and the switch.
• After all the LED lamps have turned off,
the control panel will flash and change
to configuration mode.
NOTE:
• Tools ship from the factory set to "F"
mode (torque control function off).
• The control panel will turn off if the tool
is not operated for a period of 5 min-
utes.
Configuring the torque clutch setting
but-
Display
1. Press the
clutch setting that is appropriate for the
work being performed.
As the
is pressed
29
• "F" indicates that the torque control func-
tion is off.
- 11 -
(1)
()
Battery indication lamp
and buttons to select the
button As the
is pressed
30 F 1
28 ... 3
button
2