Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Operation
i
After switching on the WBE 5210 the software ver-
sion appears on the displays of the control/display
panel for a few seconds. The two displays then show
0
the value
.
r E L.
7.1
Control/display panel
7.1.1
Overview of LEDs
12
11
10
9
8
Fig. 4:
LEDs on control/display panel
Item Description
1
Display of active (selected) balancing program and
balancing positions (refer to Section 7.2)
2
Rim diameter display
3
Balancing location display,
lights in green on attaining balancing position
4
Matching program display, lights when matching pro-
gram is active
5
Split program and matching program display, lights if
programs are active (refer to Section 8.4.2/ and
Section 9)
6
Rim width display
7
Display of distance from WBE 5210
8
Display of unit for rim width and rim diameter
lit = mm
not lit = inch
9
Operator selection display
10
Balancing program display,
lights if pax program selected
11
Display of direction to be turned for balancing position
up = turn clockwise
down = turn counter-clockwise
12
Indicator for wheel to be balanced
lit = passenger vehicle wheel
not lit = commercial vehicle wheel
Robert Bosch GmbH
1.19
1
2
7
6
7.1.2
Control keys
11
10
9
651009-05_Cv
8
Fig. 5:
Control/display panel keys
Item
Key
1
<MENU>
2
<MAT-
CHING>
3
3
<SPLIT>
4
<START>
5
<STOP>
4
6
<OK>
7
<-> or <+>
5
8
<mm/inch> Selection of unit for manual input of rim
9
<Operator> Operator selection
10
<MODE>
11
<Wheel ty-
pe>
Tab. 1:
Function of keys
7.2
Balancing programs
Operation | WBE 5210 | 35
7
6
5
Description
Performance of basic settings and confir-
mation of data input.
Selection of matching program (unbalan-
ce minimization).
Call-up and termination of program for
splitting balance weights.
Start of measurement.
End of measurement,
blocking of WBE 5210 in an emergency.
Confirmation of data input
Alteration of values for rim distance, rim
diameter and rim width.
diameter and rim width.
No function for rim distance.
Selection of balancing program.
Passenger vehicle / commercial vehicle
wheel switching
Button
Standard program for clip-on weights
Alu1: Standard program for adhesive
weights
Alu2: Concealed adhesive weights
Alu3: Inside clip-on weights /
outside concealed adhesive weights
Alu4: Inside clip-on weights /
outside adhesive weights
Alu5: Inside adhesive weights /
outside clip-on weights
Static balancing on level 1
Static balancing on level 2
Static balancing on level 3
Pax1: (Pax rim) for adhesive weights
Pax2: (Pax rim) for concealed adhesive
weights
1 695 654 697
en
1
2
3
4
|
2010-11-19
Publicité
Chapitres
Table des Matières
