State Of Charge; Starting Operation - Bosch UniversalInspect Notice Originale

State of charge

In photo mode, the state of charge of the batteries is shown in the status bar whenever a
button is pressed. When the battery symbol is empty, you have to replace the batteries
because inspections are no longer possible.
Fitting the Mirror, Hook or Magnet (see figures A and B)
The mirror (22), the hook (23) or the magnet (25) can be fitted on the camera
head (10) as accessories.
Hook the mirror (22) or hook (23) into one of the two holes (9) on the camera head (10)
and fit the sleeve (24) for attaching the accessory (see figure A).
Push the magnet (25) into the sleeve (24) and hook it into one of the two holes (9) on
the camera head (10). Fit the sleeve (24) for attaching the accessory (see figure B).
Note: The magnet (25) and the hook (23) are only suitable for moving and removing
loose, small and light objects. The inspection camera or the accessory can be damaged
with too strong a pull.
Operation
Protect the inspection camera against moisture and direct sunlight. The camera
u
cable and camera head are watertight. However, the handheld device and the batter-
ies are not protected against water. If they come into contact with water, there is a
risk of electric shock or damage.
Do not use the inspection camera if the lens on the camera head (10) has fogged
u
up. Switch the inspection camera on only if the moisture has evaporated. The in-
spection camera may otherwise become damaged.
The switched-on light (11) can become hot during operation. To avoid burns, do
u
not touch the light.
Do not subject the inspection camera to extreme temperatures or variations in
u
temperature. For example, do not leave it in a car for extended periods of time. In
case of large variations in temperature, allow the inspection camera to adjust to the
ambient temperature before putting it into operation.

Starting Operation

Switching On and Off
To switch on the inspection camera, press the on/off button (4). Photo mode (13) ap-
pears on the display (7) (magnification 1.0 and illumination 50 %).
Bosch Power Tools
English | 21
1 609 92A 69V | (26.01.2021)