User Information; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch WBE 4100 Notice Originale

en 26 | WBE 4100 | User information
2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and compa-
ny obligations, can be found in the separate manual "Im-
portant notes on and safety instructions for Bosch
Tire Service Equipment". These instructions must be
carefully studied prior to start-up, connection and opera-
tion of the WBE 4100 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety instruc-
tions for Bosch Tire Service Equipment". These
instructions must be carefully studied prior to start-up,
connection and operation of the WBE 4100 and must al-
ways be heeded.
2.3

Electromagnetic compatibility (EMC)

The WBE 4100 satisfies the requirements of the EMC di-
rective 2004/108/EG.
i
The WBE 4100 is a class/category A product as defined
by EN 61 326. The WBE 4100 may cause high-frequency
household interference (radio interference) so that
interference suppression may be necessary. In such
cases the user may be required to take the appropri-
ate action.
|
1 695 656 133 2011-02-18
3.

Product description

3.1

Intended use

The WBE 4100 is a wheel balancing machine with mecha-
nical attachment for the balancing of passenger vehicle
and motorcycle wheels with a rim diameter of 8" – 24"
and a rim width of 2" – 19". The WBE 4100 is to be used
exclusively for this purpose and solely for the range of
applications specified in these instructions. Any other
purpose is not consistent with the intended use and is
therefore not permissible.
i
The manufacturer cannot accept any liability for pos-
sible damage arising from improper use.
3.2

Prerequisites

The WBE 4100 must be installed on a flat surface
made of concrete or similar material and anchored in
position.
i
An uneven or vibrating surface can lead to inaccurate
unbalance measurements.
3.3

Scope of delivery

Designation
WBE 4100
Quick-action clamping nut
Centering flange
Centering cones (3x) and adapters
Manual vernier caliper
Weight pliers
Measuring compasses
Calibrating weight
3.4

Special accessories

Designation
Wheel lift
Set of quick-action clamping cones M10x1.25 1 695 612 100
Third centering cone dia. 89 to 132 mm
Fourth centering cone dia. 120 to 174 mm
Spacer ring for rims (large rim offset)
Three-arm flange for light commercial
vehicles
Clamping kit for swinging arms (dia. 19 mm) 1 695 654 060
Infinitely variable universal flange for cars
(3-4-5 hole)
Motorcycle flange
Shaft kit, dia. 10 mm
Calibration weight (calibrated)
Order number
Refer to rating
plate
1 695 616 200
1 695 602 400
–
1 695 629 400
1 695 606 500
1 695 602 700
1 695 654 377
Order number
1 695 900 004
1 695 653 449
1 695 606 300
1 695 606 200
1 695 653 420
1 695 654 043
1 695 654 039
1 695 653 430
1 695 654 376
Robert Bosch GmbH