12. Maintenance; Cleaning And Servicing; Spare And Wearing Parts; Calibration - Bosch WBE 4100 Notice Originale

en 40 | WBE 4100 | Maintenance

12. Maintenance

12.1

Cleaning and servicing

!
Before cleaning and servicing, switch off WBE 4100 and
disconnect mains plug.
!
Do not use any solvent-based cleaning agents. Use
alcohol or similar cleaning agents for plastic parts.
The following work is essential to ensure proper opera-
tion and high performance of the WBE 4100:
Servicing
Clean moving mechanical parts, treat with spray oil or ke-
rosene and lubricate with engine oil or a suitable grease.
12.2

Spare and wearing parts

The manufacturer cannot accept any liability for
damage arising from the use of non-genuine replace-
ment parts.
Designation
Standard centering flange
Quick-action clamping nut
Centering cone 42 - 64,5 mm
Centering cone 54 - 79,5 mm
Centering cone 74 - 111,5 mm
Weight pliers
Manual vernier caliper
Test clip
Calibration weight
Calibration weight (calibrated)
Voltage sticker
Direction of wheel rotation sticker
Tab. 2: Spare and wearing parts
|
1 695 656 133 2011-02-18
12.3
i
As part of service and upkeep (every six months),
on flange replacement or in the event of measure-
ment inaccuracies, it is advisable to calibrate the
WBE 4100 in the following sequence:
1. Flange calibration.
2. WBE 4100 calibration.
3. Perform reference measurement.
12.3.1
i
Sound and automatic start are active in the following
description (refer to Section 10).
1. Press and hold the <MENU> key.
2. As soon as
release the <MENU> key.
x
3. Press the <mm/inch> key within 1.5 seconds.
 Left-hand display shows
12.3.2
i
Sound and automatic start are active in the following
description (refer to Section 10).
1. Fit the flange (refer to Section 5).
Order number
1 695 602 400
i
Do not clamp the wheel, do not use any clamping
1 695 616 200
tools.
1 695 632 500
1 695 652 862 2. Close the wheel guard.
 Measurement commences.
1 695 605 600
1 695 606 500
i
The unbalance measured is stored on completion of
1 695 629 400
measurement.
1 695 602 700
1 695 654 377
 Electronic compensation is provided for any resi-
1 695 654 376
1 695 100 789
 Left-hand display shows
1 695 653 878

Calibration

Call-up of calibration menu

appears on the left-hand display,
CAL

Shaft unbalance correction

dual shaft unbalance.
.
C-1
.
C-2
Robert Bosch GmbH