Maintenance; Routine Maintenance (To Be Performed On A Periodic Basis); Filling The Tank; Inspecting The Cables - Videotec WASEX2T4AT Manuel D'instructions

7 Maintenance

Before doing any technical work or
maintenance on the device, make sure that
potentially explosive atmosphere is not
present.
Before doing any technical work on the
device, disconnect the power supply.
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
Whenever replacing the parts as indicated,
always use VIDEOTEC original spare parts
and meticulously follow the maintenance
instructions supplied with every spare parts
kit.
Please provide the device serial number when
requesting any replacement parts.
7.1 Routine maintenance (to be
performed on a periodic basis)

7.1.1 Filling the tank

Fill the tank with reference to the pump installation
procedure (6.3 Installation of the pump, page 14).

7.1.2 Inspecting the cables

The cables should not show signs of damage or wear,
which could generate hazardous situations. In this
case extraordinary maintenance is necessary.
7.2 Extraordinary maintenance
(to be done only under particular
circumstances)

7.2.1 Replacing the solenoid valve

Fig. 48
20

8 Cleaning

8.1 Routine cleaning (to be
performed on a periodic basis)
The outside surface of the product must
never be covered in more than 5 mm of
dust.
Frequency will depend on the type of
environment in which the product is used.
The device should be cleaned using a damp cloth;
compressed air must not be used.
9 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
MNVCWASEX_2013_EN