Web Interface; First Access To The Web; Maintenance; Factory Default - Videotec MAXIMUS MMX Manuel

6.2 Web interface

Browsers supported: Microsoft Internet
Explorer, Microsoft Edge, Google Chrome,
Mozilla Firefox.
6.2.1 First access to the web pages
The first operation in configuring the device consists
in connecting to the web interface.
To access the web interface of the product, simply
use a browser to connect to http://ip_address.
On first access, the Home page will be displayed.
For the configuration of the web interface, please
refer to the instruction manual relating to the
installed firmware version, available on the product
web page on www.videotec.com.

7 Maintenance

Before doing any technical work or
maintenance on the device, make sure that
potentially explosive atmosphere is not
present.
Do not open the device when powered and
in explosive atmosphere.
Read the product Manual A before
performing any operation.
Please provide the device serial number when
requesting any replacement parts.
MNVCMMXCAMD_1904_EN

7.1 Factory Default

It is possible to reset to the factory default settings.
The effect of the Factory Default procedure is the
same obtained through the web interface (Hard Reset
button, Tools Page).
Carry out mechanical operations with reference to
Manual A of the product.
Follow the procedure below:
• Disconnect the power supply to the unit.
• Open the housing and remove the slide.
• Set the reset dip switch to ON (SW1, 4.2 Housing
board description, page 6).
• Re-insert the slide and close the housing.
• Power the unit. Wait for 2 minutes.
• Disconnect the power supply to the unit.
• Open the housing and remove the slide.
• Set the reset dip switch to OFF (SW1, 4.2 Housing
board description, page 6).
• Re-insert the slide and close the housing.
• Power the unit.
Once the factory default procedure has
terminated, you need to configure the unit
as described in the relevant chapter (6.1
Default IP address, page 8).
9