Connection Of The Power Supply Line (Poe+); Connection Of The Power Supply Line (Version Of The Product Cabled); Connection Of The Power Supply Line (24Vac/24Vdc); Connection Of The Ethernet Cable - Videotec MAXIMUS MMX Manuel

4.3.1.2 Connection of the power supply line
(PoE+)
The Ethernet cable shield must always be
earthed via the connector. Always use a
shielded RJ45 connector.
The product can be powered using PoE+ (Power Over
Ethernet) devices in compliance with international
standard for technological information IEEE 802.3at,
with the help of an Ethernet data cable of Category
5E (or higher).
The Ethernet cable should be connected to
connector RJ45 of the housing board (J8, 4.2 Housing
board description, page 6).
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B).

CONNECTION OF THE ETHERNET CABLE

Pin number Cable color
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 3
MNVCMMXCAMD_1904_EN
4.3.2 Connection of the power supply
line (version of the product cabled)
4.3.2.1 Connection of the power supply line
(24Vac/24Vdc)
Perform the connections following the instructions
reported in the table .

CONNECTION OF THE POWER SUPPLY LINE (24VAC/24VDC)

Colour
Black 1
Black 2
Tab. 4
4.3.2.2 Connection of the power supply line
(PoE+)
The product can be directly connected to an
Ethernet switch equipped with a PoE+ (End-Span
configuration) port or a classic Ethernet switch using
a PoE Injector (Mid-Span configuration).
Function
~/+
~/-
7