Connection Of The Connector Board; Connector Board Description; Connection Of The Power Supply Line - Videotec ULISSE COMPACT DELUX Manuel D'instructions

7.3 Connection of the connector
board

7.3.1 Connector board description

BOARD DESCRIPTION
Connector Function
FUS1 Power line fuse
FUS2 Pan & Tilt electronic power supply fuse
J2 Power supply line
Tab. 1
FUS2 FUS1
J2
Fig. 10
12
7.3.2 Connection of the power supply
line
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Earth cable should be about 10mm longer
than the other two, so that it will not be
disconnected accidentally if pulled.
Check that the power supply socket and
cable are adequately dimensioned.
The power supply cable must be covered
by the silicone sheath (01) supplied. The
silicone sheath must be fastened with the
corresponding cable tie (02).
Depending on the version, the device can be
provided with different power supply voltages. The
power supply voltage is indicated on the product
identification label. (4.2 Product marking, page 9).
01
02
Fig. 11
J2 J2
N
a
L
MNVCUCHDB_2104_EN