hestan KSO 30 Manuel D'utilisation Et D'entretien page 38

OVEN CARE AND CLEANING
TO SET THE SELF-CLEAN MODE
1. Touch
EN
2. Rotate both knobs into the clean position.
- CLEAN & TIME appear. This is the clean time, its standard value is 3 hours.
3. If desired, adjust the cleaning time per instructions below.
4. When the cleaning time is accepted, the door will begin to lock.
- The "AUTO LOCK" message will flash until the door is locked.
5. When AUTO LOCK stops flashing, check that the door has been locked and will not open.
6. If door does not lock, rotate the cooking mode knob into the OFF position and do not start
self-clean; contact Hestan Customer Service for assistance.
• Provide good ventilation to the room during and immediately after self-cleaning the oven.
• To stop the cleaning mode, turn either of the two knobs from the cleaning position.
• At the end of the programmed cleaning time, the oven will automatically turn off.
TO CHANGE THE CLEANING TIME
Once Self-Clean is selected (steps 1, 2 above), the cleaning time can be changed from the
default 3 hours to as little as 2 hours for light soil or up to 4 hours for heavy soil.
3a) To change the hours, touch the
- The hours will flash.
3b) Use
+
3c) To change the minutes, touch the
• The minutes will flash.
3d) Use
+
3e) Touch
TO DELAY THE START OF CLEANING
Follow steps 1 through 6 above.
7. Touch the
begin flashing.
8. Use
+
9. To change the minutes, touch the
10. Use
+
11. Touch
- The latch starts moving to lock the oven door, the display shows "DELAY".
- When the delay time expires, self-cleaning will start.
At the end of the programmed cleaning time, the oven will automatically turn off.
36
©2019 Hestan Commercial Corporation
key to select the cavity to be cleaned, if the oven is a double.
UPPER/LOWER
or keys to change the value.
-
or keys to change the value. Hold the key to change by 10 minutes steps.
-
or wait a few seconds to confirm the new value.
TIME
key and verify that "STOP TIME" appears on the display. The hours will
TIME
or keys to change the stop time value.
-
or keys to change the value. Hold the key to change by 10 minutes steps.
-
or wait a few seconds to confirm the new value.
TIME
(CONT.)
key.
TIME
key again.
TIME
key, the minutes will flash.
TIME