Publicité
Les langues disponibles
Les langues disponibles
GB
GB
13Remove the retaining ring and the hook and
cap from the top of the freezer assembly then
inspect the top bearing, wipe clean of all
grease and apply a coating of food grade
water proof grease.
NOTE. It is recommended to use only food
grade and waterproof grease to lubricate the
freezer top bearing.
14Check the quality of ice.
NOTE. It is not abnormal for some water to
emerge fromthe ice spout with the flaker ice.
Ice flakes should be wet when formed, but will
cure rapidily to normal hardness in the bin.
C. CLEANING INSTRUCTIONS OF WATER
SYSTEM
1 Switch OFF the Master disconnect switch on
the power line.
2 Remove all ice stored in the bin to prevent it
from getting contaminated with the cleaning
solution.
3. Shut close the water shutoff valve on water
line.
4 Remove the top panels to gain access to the
water reservoir.
5. Remove the float reservoir cover andwith a
piece of copper wire short the two metal pins
of the water level sensor.
40
NOTE. Put one or both of the water sensor on
the casing of the equipment, because in this
way through the condenser sensor voltage
will be transferred and the equipment will be
switched off through that due to high tempe-
rature.
6 Place a water pan under the freezer water
inlet port, disconnect the water hose from this
port and allow the water from the freezer to
flow into the pan. Then refit the water hose to
the freezer water inlet port.
7 Prepare the cleaning solution in a plastic
container.r
8 Pour the cleaning solution into the water
reservoir.
9 Wait till the machine starts to discharge ice,
then continue to slowly pour the cleaning
solution into the water reservoir taking care to
maintain the level just below the overflow.
Publicité
