Publicité
Les langues disponibles
Les langues disponibles
GB
GENERAL INFORMATION AND INSTALLATION
A INTRODUCTION
the step-by-step procedures for the installation,
start- up and operation, maintenance and
cleaning for the F80 - F125 Modular Icemakers.
The Electronic Flakers and Superflakers are
quality designed, engineered and manufactu-
red. Their ice making systems are thoroughly
tested providing the utmost in flexibility to fit the
needs of a particular user.
B. UNPACKING AND INSPECTION
Icemaker
1 Call you rauthorizedI Distributor or Dealer for
proper installation.
2 Visually inspect the exterior of the packing
and skid. Any severe damage noted should
be reported to the delivering carrier and a
concealed damage claimformfilled in subjet
to inspection of the contents with the carrier's
representative present.
3 a) Cut and remove the plastic strip securing
the carton box to the skid.
b) Cut open the top of the carton and remove
the polystyre protection sheet.
6
NOTE. To retain the safety and performance
built into this icemaker, it is important that
installation and maintenance be conducted
in the manner outlined in this manual.
c) Pull out the polystyre posts from the cor-
ners and then remove the carton.
d) Lift the whole carton and pull it out from
the device.
4 Remove top and sides panels of the unit and
inspect for any concealed damage.
Notify carrier of your claim for the concealed
damage as stated in step 2 above.
5 Remove all internal support packing and
masking tape.
6 Check that refrigerant lines do not rub again-
st or touch other lines or surfaces, and that
the fan blades move freely.
7 Check that the compressor fits snugly onto
all its mounting pads.
8 See data plate on the rear side of the unit and
check that local main voltage corresponds
with the voltage specified on it.
Publicité
