Charging The Battery, Leds; Charging The Battery; Displaying State Of Charge; Leds On Battery - Stihl HTA 66 Notice D'emploi

6 Charging the Battery, LEDs

6 Charging the Battery, LEDs
6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

Displaying State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
There is a malfunction in the pole pruner or battery.
0458-191-9621-A

7 Assembling the Pole Pruner

7.1
► Switch off the pole pruner and remove the battery.
1
80-100%
60-80%
► Align the shaft (1) as shown in the figure.
40-60%
20-40%
► Push the shaft (1) into the clamping piece (3) in such a
way that the recesses (5 and 6) are in line.
► Push the shaft (1) into the clamping piece (3) as far as it
0-20%
will go in such a way that the clamping piece (3) is over the
handle hose (7). Take care not to damage the cable (2).
► Fully tighten the screw (4).
The shaft need not be removed again.
7.2
7.2.1
The guide bar and saw chain combinations that can be used
with the chain sprocket are listed in the specifications,
@ 20.1.
► Switch off the pole pruner and remove the battery.

Assembling the Pole Pruner (HTA 86)

3
2
4
5
6
7

Mounting and Removing the Bar and Chain

Mounting the Guide Bar and Saw Chain
English
90°
90°
57