Removing/Installing Flip Back Armrest - Patriot Only - Invacare PATRIOT Manuel De L'utilisateur Et D'entretien

ARMS
REMOVING/INSTALLING FLIP
BACK ARMREST - PATRIOT ONLY
(FIGURE 3)
Removing
1. Unlock EXISTING armrest assembly by flipping the
arm assembly release levers located on the side rail
to the UP (HORIZONTAL) position as shown in DE-
TAIL "C".
2. Pull up on the EXISTING armrest to remove from
the arm socket.
3. Repeat STEPS 1-2 for opposite side of wheelchair, if
necessary.
4. Install the NEW/EXISTING armrest on to the wheel-
chair. Refer to INSTALLING in this procedure of the
manual.
Installing
1. If necessary, unlock NEW/EXISTING armrest assem-
bly by flipping the arm assembly release levers lo-
cated on the side rail to the UP (HORIZONTAL) po-
sition as shown in DETAIL "C".
2. Install NEW/EXISTING armrest assembly into the
arm sockets.
3. Lock the armrest assembly by flipping the arm as-
sembly release levers located on the side rail to the
DOWN (VERTICAL) position as shown in DETAIL
"C".
4. Repeat STEPS 1-3 for opposite side, if necessary.
*DETAIL "C"
FRONT OF WHEELCHAIR
Unlocked
Release Levers
Position
OUTSIDE OF
WHEELCHAIR
Locked Position
RIGHT SIDE
*NOTE: Detail "C" is a top view of the armrest release
levers. Right side and left side are determined by sit-
ting in the wheelchair.
Unlock
(Horizontal)
Armrest
Release
Lever
Arm Socket
FIGURE 3 - REMOVING/INSTALLING FLIP FIGURE 3 - REMOVING/INSTALLING FLIP FIGURE 3 - REMOVING/INSTALLING FLIP FIGURE 3 - REMOVING/INSTALLING FLIP FIGURE 3 - REMOVING/INSTALLING FLIP
BACK ARMREST - PATRIOT ONLY BACK ARMREST - PATRIOT ONLY BACK ARMREST - PATRIOT ONLY BACK ARMREST - PATRIOT ONLY BACK ARMREST - PATRIOT ONLY
19
PROCEDURE 4
Armrest
Unlocked
Position
OUTSIDE OF
WHEELCHAIR
Locked Position
LEFT SIDE
Lock (Vertical)
Armrest
Release
Height
Lever
Adjustment
Lever Arm
Socket
A
R
M
S