Installing/Removing Chest Positioning Strap - Invacare PATRIOT Manuel De L'utilisateur Et D'entretien

PROCEDURE 5
INSTALLING/REMOVING CHEST
POSITIONING STRAP (FIGURE 11)
1. Remove the two (2) mounting screws and washers
securing the back upholstery to the back cane.
S
2. Do one (1) of the following:
E
A. To install the chest positioning strap, proceed to
A
STEP 3.
T
B. Remove the two (2) existing chest positioning
/
strap halves from the back upholstery.
B
3. Engage the two (2) halves of the NEW chest posi-
A
tioning strap.
C
4. Align the mounting hole on one (1) end of the NEW
K
chest positioning strap with the mounting hole on the
back upholstery and back cane.
5. Secure the NEW chest positioning strap and back
upholstery to the back cane with one (1) mounting
screw and washer. Tighten securely.
NOTE: Ensure strap is not twisted and oriented properly
when installing.
6. Repeat STEPS 4-5 for opposite side of NEW chest
positioning strap.
Engage These Ends
Chest
Positioning
Strap Half
Back
Cane
NOTE: Only Hook and Loop style chest positioning strap
shown. Auto style chest positioning strap attaches the
same way.
FIGURE 11 - INSTALLING/REMOVING
CHEST POSITIONING STRAP
24
SEAT/BACK
Chest
Positioning Strap Half
Washer
Back
Upholstery
Mounting
Screws
Washer