Practical Flight Advice For The First Start - Reely Hcp80 3D Rtf Notice D'emploi

g) Practical Flight Advice for the First Start
• Even though the model can fly in the narrowest of spaces, for the first test flights we recommend using a free space
of about 3 x 3 m.
• The support should be flat (tiles, parquet flooring, or similar) to allow you to determine even before take-off if the
model tends to drift off in a particular direction.
• Place yourself exactly behind your helicopter. As long as you can see your model from behind, it will react to the
control commands: right, left, forward, backward exactly as you see it. Whereas, if the cockpit of the model points
towards you, it reacts exactly the opposite way from your steering commands at the transmitter from your view.
Attention!
If the rotors hit any objects and are blocked or if the model falls over when standing, slide the pitch stick
(also see figure 1 item 8) into the bottom-most position at once so that the two drive motors are no longer
supplied with power.
Caution!
Never try grabbing the flying helicopter with your hand. There is an increased danger of injury!
Once the LED in the model helicopter starts to flash, land your model helicopter immediately to avoid harm-
ful deep discharge of the flight battery.
Switch the rocker „Gyro" to the rear in the switch position 1 so that the gyro function as well as the accelera-
tor sensors is activated and the model helicopter has the maximum flight stability due to this.
84