Gram KPS 120 Mode D'emploi page 30

Description of parameters:
Parameter Description
P01 Room temperature setpoint, soft
P02 Room temperature setpoint, hard
P03 Probe temperature setpoint, soft
P04 Probe temperature setpoint, hard
P05 Duration of the process
P06 Hard phase duration expressed in % relative to P05
P07 Room temperature setpoint, storage
N01 Room temperature setpoint
N02 Probe temperature setpoint
N03 Duration of the process
N04 Room temperature setpoint, storage
A01 Temperature alarm hysteresis
A02 High temperature alarm, relative to P07
A03 Low temperature alarm, relative to P07
A04 High temperature alarm, relative to N04
A05 Low temperature alarm, relative to N04
A06 Temp.alarm delay from storage or defrost start
A07 Temp.alarm delay
S10 Type of manually started defrost:
0=electric (or compressor stop), 1=hot gas (not
avalible), 2=air defrost.
For setting other parameters, refer to the operating- and servicemanual.
If necessary, it can be ordered from your dealer.
Reset of memory:
Select Set Up 05. Push
Push to confirm the reset.
Push to exit the menu without resetting the memory.
Restore default parameters:
Push Set Up 06. Push
Push to restore the default parameters.
Push to exit the menu.
765042145
Blast chilling, positive
Blast chilling, negative
Alarms
Defrost
to reset the memory:
to enter the menu, the display shows:
rev.000
Default
-5°C
-25°C
3°C
20°C
90 in
60%
2°C
-25°C
-18°C
240 n
-22°C
2°C
10°C
-10°C
10°C
-10°C
60 in
30 in
Model Model
CF SF
2
Reset memory?
No OK
No
Min. Max.
-30°C 30°C
-40°C 30°C
-30°C 30°C
-30°C 30°C
0 min 900 min
0% 100%
-30°C 30°C
-40°C 30°C
-30°C 30°C
0 min 900 min
-40°C 30°C
0°C 10°C
0°C 50°C
-50°C 0°C
0°C 50°C
-50°C 0°C
0 min 300 min
0 min 300 min
0 0 2
Default
OK
30