Deleting Alarm Memory; Arming Alarm Control Centre And Deleting Alarm Memory Commensurately; Panic Alarm - Renkforce 751514 Notice D'emploi

11.4.2 Deleting alarm memory

The following input allows you to extinguish the loop LEDs. The alarm control centre must be disarmed.
• Enter one of the 8 programmed user codes.
*
• Press the " " button.
• Press the "3" button.
• Press the "#" button for confirmation.
If the alarm control centre is still armed then this input has no effect. 5 signal tones are emitted
as an error message.
11.4.3 Arming alarm control centre and deleting alarm memory
commensurately
Proceed as follows to extinguish the LEDs which are lit as a result of the alarm saving function and to arm
the alarm control centre again:
• Enter one of the 8 programmed user codes.
*
• Press the " " button.
• Press the "6" button.
• Press the "#" button for confirmation.
This option is only available if the alarm control centre is disarmed.

11.5 Panic alarm

This function lets you raise the alarm at any time. To do so you need to hold down any two buttons at the
same time on the control panel for three seconds.
The alarm control centre can be in any status (armed or disarmed).
There is no change in the display on the remote control panel.
The alarm control centre raises the alarm via the alarm outputs and activates the telephone
dialler.
136