Fitting And Removing The Glass Panels - Junker JB23PP50 Mode D'emploi

Unhooking the door
1. Fully open the oven door.
Remove both locking levers located on the right and left hand
2.
sides (figure A).
Fully close the oven door as far as possible (figure B). Grip
3.
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.
$
Hanging the door
Rehang the door by following the same steps but in reverse
order.
1. When refitting the door, check that both hinges are
positioned exactly inside their respective openings
(picture A).
The bottom groove of the hinges must fit snugly on both
2.
sides.
$
The door may be left crooked if the hinges are not mounted
properly.
3. Reclose the attachment levers (picture C). Close the oven
door.
&
ã=
Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
30
%
%

Fitting and removing the glass panels

The glass panels of the oven door can be removed to make
cleaning easier.
Removing
Unhook the oven door and position it on a cloth with its
1.
handle pointing downwards (figure A).
2. First, unscrew the two lower bolts then the two upper bolts
(figure B).
$
3. Completely remove the door base (figure C).
&
Remove the two clips from the top of the glass (figure D). To
4.
do this, slightly press down on the clip with your thumb and
pull on the tab with your index finger (figure E).
'
Lift the inside glass, push it slightly upwards then remove it
5.
from below (figure F).
)
Clean the glass panels using a glass cleaning product and a
soft cloth.
Do not use abrasive or corrosive cleaning products, glass
scrapers or hard metal scourers as these could damage the
glass.
%
(