Programming The Oven; Type Of Heating And Temperature; Rapid Heating; Setting The Time Functions - Junker JB23PP50 Mode D'emploi

Programming the oven

There are different ways to programme the oven. Programming
the type of heating, temperature or grill power. The oven can be
programmed with the cooking time (duration) and the end time
for each dish. For more information, see the chapter Setting the
time functions.
Note: We recommend preheating the oven before inserting the
food in order to avoid condensation on the oven glass.

Type of heating and temperature

Example in the picture: top and bottom heat
Select the type of heating using the function control knob.
1.
2. Set the temperature or required grill power using the
sensors.
The oven will begin to heat up.

Setting the time functions

This oven has various time functions. The
the menu and moves through the different functions. The time
symbols remain lit up while settings are programmed. A time
function that has already been programmed can be modified @ A
with the or sensors.

Timer

The timer works independently of the oven. The timer has its
own signal. You can therefore distinguish whether the time set
for the timer or the automatic oven shut-off have finished
(cooking time).
0
Press the sensor.
1.
V
The symbol lights up on the display panel.
Programme the timer using the
2.
Sensor suggested value
Sensor suggested value
The programmed time is shown after a few seconds. The time
set for the timer starts to count down. The
on the display panel and the time elapsed is displayed.
%
at 190 °C
0
sensor activates
@ A
or sensors.
@
= 10 minutes.
A
= 5 minutes.
V
symbol lights up
Switching the oven off
Set the function control knob to the zero setting.
Changing the settings
The type of heating and the temperature or grill power may be
changed at any time.

Rapid heating

With the rapid heating setting, the oven reaches the
programmed temperature very quickly.
Rapid heating must be used for temperatures of more than
100 ºC.
To ensure uniform cooking, the food must not be put into the
oven until rapid heating has been completed.
Select rapid heating
1.
Select the required temperature using the
2.
s
The symbol lights up on the display panel. The oven will begin
to heat up.
End of rapid heating
A signal will sound, the
the oven and select the required function and temperature.
@ A
Cancelling rapid heating
or
Set the function control knob to the zero setting. The oven
switches off.
Note: With the rapid heating function you cannot programme
the cooking time duration.
The time set for the timer has elapsed
A signal will sound. The display panel will show
off the timer using the
Changing the time set on the timer.
Change the time set for the timer using the
The altered time is shown after a few seconds.
Cancelling the timer
When the oven switches off, the timer continues working.
Resetting the timer to
switches off.
Viewing the time settings
If several time functions are programmed, the corresponding
symbols light up on the display panel.
To view the timer 0
the time , press the
symbol lights up. The corresponding value will be shown for a
few seconds on the display panel.
J
using the function control knob.
s
symbol will go out. Place the food in
0
sensor.
‹‹ ‹‹ A
: with the sensor. The timer
V
x
, the cooking time 0 , the end time
sensor repeatedly until the required
@ A
and sensors.
‹‹ ‹‹
: . Switch
@ A
or sensors.
y
or
25