Factory Settings; Software Version; Cleaning - TechniSat DIGITRADIO 1 Manuel D'utilisation

9.4

Factory settings

When you change the location of the device, e.g. if you move house, it is possible that
the stored stations can no longer be received. By resetting to the factory settings, you
can delete all the stored stations in this way and then run a new station scan.
> Press the MENU button and use the t or u buttons to select the [Factory
Settings] entry. Press the OK button.
> To apply the factory settings, use the t or u buttons to select the [Yes] entry,
then press the OK buttons.
All previously stored stations and settings will be deleted. The device will now
be in the status it was in when supplied.
> [Restarting...] now appears in the display and the device will start with the
language selection ([Language]). Use the t or u buttons to select one of the
available languages and confirm the selection by pressing the OK button. The
device then automatically runs a full scan in DAB mode. The display information
shows the progress during the scan, plus the number of digital radio stations
found. The first DAB+ station is played after the scan has finished.
56
9.5

Software version

You can review the currently installed software version under Software Version.
> Press the MENU button and use the t or u buttons to select the [Software
Version] entry.
> Press the OK button. The current software version is displayed.
10

Cleaning

To prevent the risk of electric shock, you should not clean the device with a wet
cloth or under running water. Disconnect from the mains and switch the device
off before cleaning!
Abrasive sponges, abrasive powders and solvents such as alcohol or petrol may
not be used.
None of the following substances may be used: salt water, insecticides, solvents
containing chlorine or acid (ammonium chloride).
EN
FR
IT
NL
NW
DK
PL
CZ
SK
57