Overwriting/Deleting A Stored Station Position; Signal Strength; Manual Settings; Volume Adjustment (Drc) - TechniSat DIGITRADIO 1 Manuel D'utilisation

7.2.5 Overwriting/deleting a stored station location
> Simply save a new station to a favourites storage location as described.
If factory settings are applied, all storage locations will be deleted.

7.2.6 Signal strength

> Briefly press the MENU button and use the t or u buttons to select the
[Display] entry, then press OK.
> Use the t or u buttons to select the [Signal Strength] entry, then press OK.
> Exit the menu by pressing MENU several times.
> The signal strength is shown in the display via a bar diagram.
Stations with a signal strength below the necessary minimum signal strength
are not broadcasting a sufficiently strong signal. Align the telescopic aerial as
described in Section 5.3.3 if necessary.
42

7.2.7 Manual settings

This menu item is used for checking the channels and can be used for aligning the
aerial.
> Briefly press the MENU button and use the t or u buttons to select the
[Manual Settings] entry, then press OK.
> Use the t or u and OK buttons to select a channel (5A to 13F). Its signal
strength will then be shown in the display. If a DAB+ station is received on
a channel, the station's ensemble name is displayed. The aerial can then be
aligned for maximum signal strength.
Stations with a signal strength below the necessary minimum signal strength
are not broadcasting a sufficiently strong signal. Align the telescopic aerial as
described in Section 5.3.3 if necessary.

7.2.8 Volume adjustment (DRC)

The volume adjustment menu item is used to set the compression rate, which
equalises dynamic fluctuations and the associated volume variations.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
43